Error Messages - Casio Celviano 6ES1A User Manual

Using a Memory Card

Error Messages

One of the error messages below appears on the display when a problem occurs.
• All mentions of "memory card" in the following table refer to an SD memory card.
Display
Message
Convert There is not enough Digital Piano memory available to
convert a recorder song (page E-34) to SMF data and store
it on the memory card.
FileName You are trying to use the procedure under "Renaming a
Memory Card File" (page E-47) to change to a file name
that already exists on the memory card.
Format 1. The current memory card format is not compatible
with this Digital Piano.
2. The memory card capacity is greater than 2GB.
3. There is something wrong with the memory card.
MediaFull 1. There is not enough room available on the memory
card.
2. There is not enough room available in Digital Piano
memory.
Media R/W 1. Memory card data is corrupted.
2. Digital Piano memory is corrupted.
No Card 1. The memory card is not loaded correctly in the Digital
Piano's memory card slot.
2. The memory card was removed while some operation
was in progress.
No Data You tried to save a Digital Piano user area (user rhythm,
user rhythm song, etc.) that does not contain any data to
the memory card.
No File 1. There is no MUSICDAT folder (page E-46) on the
memory card.
2. There is no loadable or playable data in the
MUSICDAT folder, or there is no playable data in a
song playback folder (MUSIC__B, etc.)
Not SMF01 You are attempting to play back SMF Format 2 song data. This Digital Piano supports playback of SMF Format 0 or Format 1
Protect The memory card is write-protected.
ReadOnly A read-only file with the same name you are trying to use
is already stored on the memory card.
SizeOver 1. The data on the memory card is too big to play.
2. The data you are trying to load is too large.
WrongDat 1. The memory card data is corrupted.
2. The memory card contains data that is not supported
by this Digital Piano.
E-50
Cause Required Action
Reduce the size of the recorder song data by deleting unneeded
tracks (page E-37), if there are any.
Use a different file name.
1. Format the memory card on the Digital Piano (page E-45).
2. Use a memory card with a capacity of 2GB or less.
3. Use a different memory card.
1. Delete some of the files on the memory card to make room for
new data (page E-47), or use a different card.
2. Delete some or all user data from Digital Piano memory to make
room for new data.
1. Use a different memory card.
2. Back-up Digital Piano memory data by copying it to your
computer, and then turn the Digital Piano off and then back on
again.
• Note that you may not be able to back-up Digital Piano data
in certain cases.
1. Correctly load the memory card into the memory card slot.
2. Do not remove the memory card while any operation is in
progress.
Select a user area that contains data.
1. Create a MUSICDAT folder on the memory card or format the
memory card on the Digital Piano (page E-45).
2. Move the file you want to load or play into the memory card's
MUSICDAT folder. For song playback, you can place the song
data into any one of the following folders: MUSIC__B,
MUSIC__C, or MUSIC__D.
only.
Use the memory card's write protect switch to enable writing.
• Use a different name to save the new file.
• Remove the read-only attribute from the existing file and
overwrite it with the new file.
• Use a different memory card.
1. This Digital Piano supports playback of song data files with a
maximum size of 320KB.
2. The following is the maximum data size (per data item) when
loading data into Digital Piano memory.
User rhythm: Approximately 40KB
User Song: 320KB
User Music Preset: Approximately 8KB
—
B