Advertisement
Take the D10M servo and insert it from below into the prepared cutout in the central part. Secure the servo with
glue. Drop the glue in the corners of the servo and spray it with an activator.
After gluing the servo, glue the lower part of the airplane to the center part. Be careful not to glue the moving
part of the servo. Using a triangle, make sure that the lower part is glued perpendicularly to the center along
the entire length of the airplane. Then spray the joint with an activator.
9
Advertisement
Need help?
Do you have a question about the Complete set Yak 55 and is the answer not in the manual?