How To Replace The Separating Knife - Roland SC-545EX Print&Cut User Manual

5-7 How to Replace the Separating Knife

Do not touch the tip of the separating knife with your fingers.
Doing so may result in injury.
Do not touch the control panel while head cleaning or other cleaning is in progress.
The print-head carriage may move and cause injury.
If the separating knife becomes dull, replace with the included replacement blade.
Press the [MENU] key, and press the [
1
to make the following screen appear on the dis-
play.
Press the [ENTER] key to make the following
2
screen appear on the display.
When the screen shown in the figure appears, the print-
head carriage simultaneously moves to the left.
Open the front cover, and then remove the
3
separating knife.
If a blade remains in the print-head carriage, use
the tweezers in the cleaning kit to remove it.
Replace with a new knife.
4
Install the separating knife.
5
Close the front cover and press the [ENTER]
6
key.
] key
Positioning
groove
MENU
REPLACE KNIFE
FINISHED ?
(2) Grasp the screw portion,
and slowly pull it out in
the direction of the arrow.
(1) Loosen the screw
until it slips out.
The knife is secured in
place by the magnet.
(1)Grasp the screw portion
and slowly insert it into
the groove.
(2) Tighten the screw.
Chapter 5: Maintenance
93