Step 4: Remove The Protective Media - Roland SC-545EX Print&Cut User Manual

Step 4: Remove the Protective Media

The protective media shown below is attached to this machine when it is shipped from the factory. When you have
finished installing the machine, remove all protective media.
Front
5) Peel off the tape.
If the screw for the retainer is difficult to loosen, use a screw-
driver to remove it.
Rear
Chapter 1: Getting Started
26
1)
Packing
Remove packings.
6) Peel off the tape, and
remove the packing.
7) Remove the retainer.
Packing
2) Peel off the tape.
4) Peel off the tape,
and remove the pack-
ing. (Pull straight back
toward you to extract.)
8) Loosen the screw, and remove
the packing.
1-3 Assembling and Installing
3) Peel off the tapes, and
remove the packings.
9) Attach the retainer you removed
in step 7).
Retainer