Roland SC-545EX Print&Cut User Manual page 108

6-2 Description of Menus
Top menu
PERIODIC CL.
UNIT
FACTORY
DEFAULT
SYSTEM REPORT
ENV.MATCH
PREFEED
CUTTING PRIOR
REPLACE KNIFE
INK REMAINING
Chapter 6: Menus and Keys
106
Submenu
— This specifies whether the automatic cleaning during printing is en-
abled or disabled.
When set to [ENABLE], automatic cleaning is performed during print-
ing, and prevents drop-out and ink drips. Because automatic clean-
ing is performed during printing, printing may take more time. The
lower the temperature of the work area, the greater is the number of
times that automatic cleaning is performed.
Also, because printing is interrupted temporarily during automatic
cleaning, horizontal stripes may occur in the printing.
— This selects millimeters or inches as the unit of measurement for the
width displayed on the top menu after setting up the media. When
inch display is used, values are displayed to the first digit to the right
of the decimal point.
— This returns all menu settings to their original values when shipped
from the factory.
For more about the factory defaults for the various settings, see the
"Default value" entry for each menu setting in this section.
— This prints the current status of settings and other system informa-
tion.
— This performs automatic adjustment on the machine to obtain a state
optimized to the operating environment (temperature and humidity).
— This specifies whether the media prefeed function is enabled or dis-
abled.
When set to [ENABLE], an amount of media equal to the size of the
data sent from the computer is fed out first, and then printing or cut-
ting are performed.
— This setting is made cutting conditions set with a program are made
to take priority. When set to [MENU], cutting is performed using the
values set with the machine.
— This setting is used when replacing the separating knife, or installing
or removing cutter blade
— This shows the amount of ink left after each of the ink cartridges has
been installed.
The fewer the markers (" "), the less ink is left.
* If a partially used ink cartridge is removed and reinstalled, or if a
partially used ink cartridge is installed, the cartridge is taken to be
unused, and the displayed amount of remaining ink is not true.
Function Setting Default
range value
D I S A B L E / DISABLE
ENABLE
mm / INCH mm
— —
— —
— —
DISABLE/ DISABLE
ENABLE
COMMAND/ COMMAND
MENU
— —
— —