Driveline Attachment; Shield Assembly - Side Drives - Lift And Pull; Shield Assembly - Main Input - Lift And Pull - RHINO TURBO 96 TURBO 96 Operator's Manual

Rhino mounts lawn mower user manual

Table of Contents

ASSEMBLY

DRIVELINE ATTACHMENT

Before starting assembly, make certain that all

paint, dirt, and grease are removed from gearbox

shaft (1). To ease assembly apply a light coat of

grease to splines and assemble. Do not assemble a

driveline without a shield. (Figure Asm-R-0129)

Attach the slip clutch end of the driveline to the

gearbox input shaft securely. Make certain that the

slip clutch is fully onto the input shaft splines.

Tighten the locknuts (2) alternately until they have

reached the proper torque. Refer to Torque Chart in

Maintenance Section.)

Attach the Brackets (1& 2) to the Gearbox. Install

Shield (3) to brackets (1 & 2) with Bolt (4)

Flatwashers (5) and locknut (8). Close Shield and

retain with Bolt (6), Flatwasher (5) and with Thumb

nut (7). (Figure Asm-R-0297) Proceed to attach

Divider Shield (1) with bolt (2) and Lockwasher (3).

Retain Divider Shield with Thumb Nut (4) and

Flatwasher (5). (Figure Asm-R-0298

Attach the Bracket (1) to the Center Gearbox with

M10 x 35 Bolts (2), and Flatwasher (3). Install

Shield (5) and retain with 1/2" Wing Nut (4).

TURBO 96 01/11

Assembly Section 3-10

Table of Contents

Show Quick Links

Table of Contents

Turbo 96