Table of Contents
Advertisement
ATTENTION!
Motor damage due to incorrect operation!
Do not press too hard onto the pressing cone during the pressing
process. If it is clearly heard that the motor starts operating slower or
stops, relieve the pressing cone.
Appliance Preparation
1. Prior to first use, clean all the removable components of the appliance (strainer,
juice container, pressing cone) thoroughly, observing instructions in section 6
'Cleaning'.
2. Rinse these components with fresh water and leave them to dry in open air.
3. Place the juice container on the motor block.
4. Insert the strainer in the juice container.
5. Secure the right pressing cone onto the motor drive.
NOTE!
The large and medium pressing cones are delivered inserted one into
another. To use the medium pressing cone, remove it from the large one.
EN
The large pressing cone may be used only in conjunction with the medium
one due to the fixing of the motor drive inside the cone.
6. Select:
– the largest pressing cone, for
example, for large oranges,
grapefruits:
– the medium pressing cone for
medium oranges;
– the smallest pressing cone for
lemons and limes.
Pressing Citrus Juice
1. Make sure that during pressing there is a juice container underneath the juice
spout.
2. Prepare citrus fruits and slice them in halves.
3. Make sure the ON/OFF switch is set in 'O' position.
4. Plug the appliance into a suitable single socket.
5. Switch the ON/OFF switch to 'I' position.
6. Place the prepared fruit halves with the cut face on the pressing cone.
12 / 14
Installation and operation
Fig. 3
150140
Advertisement
Table of Contents
