Table of Contents
Advertisement
5.8 User Interface Language Settings
Using parameter 96.01, in the favourite parameters group, the desired language can be selected from the
following: English, German, Italian, Spanish, Portuguese, Dutch, French, Danish, Finnish, Swedish, Russian,
Polish, Czech, Hungarian and Turkish.
Select the interface language, highlight it (unless it is already highlighted) and then press the SAVE key
(
)
NOTE: Once the language has been selected, stand by for a few minutes whilst the language file is
downloaded to the control panel.
5.9 Operating Principle Definition
Using parameter 47.24, the vacuum system's operating principle can be changed. There are two types of
operations: whether to carry out the self-cleaning cycle with the turbine active or in stand-by can be set for
each of these.
●
Traditional System: Switching the vacuum system on or off by inserting or removing the working
hose in the inlet port.
●
IWS System: Switching on the system using the button on the handle. The system switches off
automatically when all the inlet ports are closed.
Unless otherwise requested by the customer, all the vacuum systems are factory configured and tested
using the 47.24=2 configuration, i.e., vacuum system using the traditional system and self-cleaning (if
present) with turbine on. The table below shows the possible vacuum system configurations.
DEFINIZIONE PRINCIPIO DI FUNZIONAMENTO
Parameter set
Description
IWS Function +
47_24
0
Self-cleaning with turbine
OFF
STANDARD + Function
47_24
1
Self-cleaning with turbine
OFF
STANDARD + Function
47_24 2
Self-cleaning with turbine ON
IWS Function +
47_24 3
Self-cleaning with turbine ON
Details
Switch-off frequency to be set using 47_04 in HZ
Switch-off delay to be set using 47_11 in seconds
Direct start and delayed stop using 47_12 in seconds.
Direct start and delayed stop using 47_12 in seconds.
Switch-off frequency to be set using 47_04 in HZ
Switch-off delay to be set using 47_11 in seconds
27
Advertisement
Table of Contents
