Table of Contents
Advertisement
Use and Maintenance Manual
MONOBLOCK Vacuum Unit
4.
Installation of the MONOBLOCK vacuum unit
This system is designed to be installed by adequately trained and instructed personnel.
The entire system must be installed by qualified personnel in full compliance with standards
of workmanship and with applicable standards and regulations.
During installation operations use appropriate items of personal protection equipment.
Failure to use appropriate items of personal protection equipment during movement and
unpacking may expose the operator to the risk of crushing of the feet due to loss of
stability.
Failure to wear safety gloves prevents a safe grip during movement operations with the risk
of accidental falls.
4.1 Choice of installation position for the vacuum unit
The choice of installation position must be based on these criteria:
●
The Monoblock vacuum unit must be installed indoors in well-ventilated rooms, preferably in a
service room on the lowest floor of the building, like a garage or technical utilities room, or in external
locations, provided that the vacuum unit is always protected against bad weather.
●
The selected position must have a clear and well-lit space around the main vacuum unit, so as to
facilitate maintenance and repair operations.
●
The main vacuum unit must not be installed in rooms where:
- there is a source of heat in the immediate vicinity
- ambient temperature can reach values lower than 5°C and above 35°C
- humidity is very high or flooding may occur
- flammable or explosive products are present
- in environment presenting ionizing radiations
Its location must be able to realize the pipe for the expulsion of the air.
It is the duty of the user to make a valuation of the noise pollution to the activity in the area of installation
of the vacuum central.
17
>>> Installation
Advertisement
Table of Contents
