Porter-Cable 7319 Instruction Manual page 8

900005 - 11-30-01.qxd
2. Turn depth adjusting wheel (Fig. 3) clockwise, looking at top of wheel, to
raise cutter reducing depth of cut or counterclockwise to lower cutter for
increasing depth of cut.
3. Tighten base locking screw securely and make a test cut in scrap
material and check depth of cut.
4. Repeat steps 1 through 3 until desired depth of cut is achieved.
LOCKING
SCREW
ADJUSTING SUB-BASE ALIGNMENT
Applications using a templet guide require the bit to be centered within the
guide. This, in turn, requires the center hole in the sub-base to be in line with
the collet of the motor unit. Your model has an adjustable sub-base which
has been aligned at the factory. If the sub-base has been removed and/or
readjustment is required, proceed as follows:
CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
1. Install 42054 Templet Guide (available as an accessory) to the subbase
and tighten securely.
2. Loosen sub-base mounting screws just enough to allow sub-base to
move on base.
3. Install a straight
securely.
4. Assemble motor unit to base, align hole in templet guide with
diameter bit and adjust depth of cut so that bit extends through templet
guide. Tighten motor unit in base.
5. Tighten sub-base mounting screws securely.
Model 73100 Edge Guide Kit, consisting of parts listed below, is available as
an accessory for use with laminate trimming bits, without pilots (43515 and
44858), on Model 7310 Trimmer.
A Base and Roller Guide - for use with 44858 bit.
B Edge Guide - for flush trimming with 43515 bit.
C Edge Guide - for bevel trimming with 43515 bit.
D Straight Edge Guide - for straight trimming with 44858 & 43515 bits.
E Guide Setting Gauge
F Mounting Screws
G Wrench
CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2/12/02 10:45 AM Page 8
SPRING WASHER
DEPTH ADJUSTING
WHEEL
Fig. 3
1 " diameter bit in collet of motor unit and tighten
/
4
73100 EDGE GUIDE KIT
8
1 "
/
4