Porter-Cable 7319 Instruction Manual page 10

900005 - 11-30-01.qxd
3. Install guide setting gauge (E) (Fig. 4) to trimmer so that hole in end of
gauge may be positioned over stud in guide.
4. Adjust guide until hole in gauge fits over stud on end of gauge. Tighten
all screws securely.
5. Remove guide setting gauge from trimmer and install 43515 bit as
outlined under TO INSTALL BIT.
NOTE: It will be necessary to separate motor from base to remove
setting gauge and install bit.
6. Adjust depth of cut so that the straight portion of bit extends below
trimmer base at least equal to the thickness of material to be trimmed.
7. Make a trial cut on scrap material to check alignment. Readjust if
necessary.
BEVEL TRIMMING WITH 43515 BIT
1. Follow steps 1 thru 5 under FLUSH TRIMMING WITH 43515 BIT, except
install bevel trimming guide (C) (Fig.4). This guide may be identified by the
Letter "B" molded on.
2. Adjust depth of cut so that only the bevel portion of the bit extends
below trimmer base at least equal to the thickness of material to be trimmed.
3. Make a trial cut on scrap material to check alignment. Readjust if
necessary.
USING STRAIGHT EDGE GUIDE
The Straight Edge Guide (D) (Fig. 4) may be used with either 44858 or 43515
bit for trimming long straight edges.
Assemble to guide base and adjust similar to other guides.
MODEL 7319 TILT BASE TRIMMER ASSEMBLY
Model 7319 Tilt Base Trimmer is completely assembled at the factory. The
base is assembled or removed from Model 7301 motor with base locking
screw (A) Fig. 6.
NOTE: There is a flat washer (B) Fig. 6, on the locking screw.
Model 7319 Tilt Base is designed for use with 43216 flush trim bit for
trimming into corners. It may also be used with other "self pilot" trim
bits for conventional trimming at 90° setting.
A
2/12/02 10:45 AM Page 10
C
D
B
Fig. 6
10