Typical Applications - Porter-Cable 7319 Instruction Manual

900005 - 11-30-01.qxd
TRIMMING 3
/
4
VERTICAL BACKSPLASH
APPLICATION – Trimming front edge of
3 " vertical backsplash. This is an opera-
/
4
tion standard trimmers with round or
square bases are unable to do without
the use of a special bit.
Self-piloted bit
guides trimmer for
enables trimming with
one-pass trimming
backsplash in place.
every time.
OPERATION – Trimming 3
/
with the new Porter-Cable Offset Laminate
Trimmer fitted with a solid carbide self-
piloted bit.
Trims up to vertical surfaces.
UNDERSCRIBE TRIMMER BASE INCLUDED IN
ASSEMBLY
The Underscribe Trimmer Base is assembled to the Model 7301 Trimmer
Motor as follows:
NOTE: The 43109 Trim Bit must be installed into the Trimmer Motor
before attaching the motor to the Underscribe Base.
CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2/12/02 10:46 AM

TYPICAL APPLICATIONS

" IN-AND-OUT TRIMMING
OF INSTALLED CORNER
APPLICATION – Trimming into and
out of installed backsplash corner
with little or no hand trimming
required.
Triangular base
enables complete
corner trimming
with backsplash
in place.
Triangular base
" backsplash
OPERATION – The new Porter-Cable
4
Offset Trimmer will trim into and out
of 90° corners with ease using self-
piloted bit.
KIT 97311
14
Page 14
SCRIBING OF
BACKSPLASH TO WALL
APPLICATION – Accurately scribing the back
side of a preassembled panel or post-formed
backsplash. Once the lip is accurately scribed,
the trimmed portion is then pushed against the
wall and mated exactly.
Self-piloted bit
follows every
trimmer movement
to create exact
reproduction of wall
surface in one pass!
OPERATION – The guide assembly must be
removed. Using the self-piloted bit, the
Porter-Cable Offset Trimmer scribes
accurately to the wall surface.
Trims odd angled corners less
than or greater than 90°.
Front edge
of trimmer
is guided
against
wall.
Maintain 3 " separation
/
4
from wall for scribing.