Porter-Cable 7319 Instruction Manual page 13

900005 - 11-30-01.qxd
A. Remove three sub-base mounting screws.
B. Turn sub-base over and re-attach using screws removed in step A.
1. Material to be trimmed must overhang the base material by at least
2. CAUTION: Always wear safety glasses while operating a laminate
trimmer.
3. CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
4. Firmly grasp motor housing being sure switch is in the "OFF" position.
5. Verify bit is clear of foreign objects and cord will not "hang up" on any
obstructions.
6. Be sure workpiece is firmly held in place. Use clamps where necessary
to secure workpiece.
7. Plug in power supply cord. Be alert to resist starting torque of motor.
Turn motor "ON".
8. Allow motor to reach "full speed". Place base of trimmer on surface to
be trimmed and feed into work until bit pilot contacts base material. When
guiding on a previously laminated surface, always wax or lubricate the area
that trimmer will guide against.
NOTE: While operating trimmer with
tilt base at any tilt setting other than
"0" degrees, the long side of the
base must be kept perpendicular to
the piloting surface to prevent
possible work spoilage.
9. Feed from left to right with a smooth
steady motion (See Fig. 13).
10. At completion of trimming operation,
turn switch "OFF". Allow motor to come
to a complete stop before laying trimmer
down.
2/12/02 10:46 AM Page 13
Fig. 12
OPERATION
13
SUB-BASE
INVERTED
3 "
/
16
1
".
/
8
Fig. 13