Porter-Cable 7319 Instruction Manual page 4

900005 - 11-30-01.qxd
3. Always be sure collet nut is securely tightened to prevent the bit from
slipping during use.
4. Make certain that the workpiece is rigidly held in desired position and
free of obstructions.
5. Be sure cord is free and will not "hang up" during trimming operation.
6. Be sure trimmer bit is clear of work before starting motor.
7. Maintain firm grip on trimmer when starting to resist starting torque.
8. Keep hands clear of cutter when motor is running to prevent personal
injury.
9. Always hold the trimmer firmly and against the work during trimming
operation.
10. Keep cutting pressure constant. Do not overload the trimmer.
11. Be sure motor has completely stopped before setting machine down
between operations.
12. Never touch trimmer bits after use, since they may be extremely hot.
13. Never tighten collet nut without bit inserted. This will deform collet
making it impossible to insert bit.
14. Do not use Laminate Trimmer motor without the Laminate Trimmer
Base installed: loss of control could result, causing personal injury or
damage to work.
15. Some wood contains preservatives which can be toxic. Take extra
care to prevent inhalation and skin contact when working with these
materials. Request, and follow, any safety information available from your
material supplier.
16. WARNING: There are certain applications for which this tool was
designed. Porter-Cable strongly recommends that this tool NOT be modified
and/or used for any application other than for which it was designed. If you
have any questions relative to its application DO NOT use the tool until you
have written Porter-Cable and we have advised you.
SYMBOL
V ........................ volts
A ........................ amperes
Hz ........................ hertz
W ........................ watts
kW ........................ kilowatts
µF ........................ microfarads
l ........................ liters
kg ........................ kilograms
N/cm 2 ........................ newtons per square centimeter
Pa ........................ pascals
h ........................ hours
min ........................ minutes
s ........................ seconds
........................ alternating current
3 ........................ three-phase alternating current
3 ........................ three-phase alternating current with neutral
N
........................ direct current
2/12/02 10:45 AM Page 4
DEFINITION
4
Technical Service Manager
Porter-Cable Corporation
4825 Highway 45 North
Jackson, TN 38305