Playback - Sony DAT DTC-690 Operating Instructions Manual

1
)
7 £ 8
2 3
1
OFF PLAY
REC
\
TIMER
2 OPEN/CLOSE
)
3
$ › 1 ¡
• ¶
POWER
3

Playback

1
Make sure that the TIMER switch is
set to the OFF position, and then
turn on the power.
2
Insert the cassette and press the
0OPEN/CLOSE button to load the
cassette.
3
Press the 3 (play) button.
Playback begins.
If an end ID is written on the tape or a
blank section of more than 9 seconds
is detected, playback stops
automatically at the end ID position,
and the tape will be rewound to the
beginning.
To stop playback
Press the 7 button.
To stop playback for a moment
Press the 8PAUSE button.
To release pause and restart
playback
Press the 8PAUSE or 3 (play) button.
To remove the cassette
Press the 0OPEN/CLOSE button.
To rewind or fast-forward the tape
Stop the tape and press the 1 or ¡
button.
To advance the tape (cue) with
hearing the tape sound*
Press the ¡ button during playback.
To rewind the tape (review) with
hearing the tape sound*
Press the 1 button during playback.
* Sound is heard while the button is
pressed. Release the button at the
desired point. Playback resumes.
The speed of the tape increases about 4
seconds after the cue or review starts.
On the volume adjustment
Compared with the analog audio cassette
tape, a digital audio tape contains less
tape hiss noise. So be sure to turn down
the volume before playback.
Adjusting the headphones volume
Use the LEVEL control.
When the tape is played back to its
end
The tape will be rewound to the beginning
and stop automatically.
If tape noise exists, or sound quality
has deteriorated
The head may be contaminated. Clean the
head, using a cleaning cassette (See page
53).
43