Adjusting The Position; Erasing - Sony DAT DTC-690 Operating Instructions Manual

START ID ERASE
)
7 £ 8
$ › 1 ¡
ERASE
START ID
START ID
Start ID

Adjusting the Position

The position of a start ID written during
recording or by using the rehearsal
function can be finely adjusted.
You can shift the start ID position about 2
• ¶
seconds (about 4 seconds in the long-play
mode) backward or forward. To shift it for
more than 2 seconds, first erase the start
ID (see below) and rewrite it manually.
1
2
START ID
ERASE

Erasing

While the start ID you want to erase
appears on the display during
playback or in the stop mode, press
the START ID ERASE button.
Make sure that the safety tab of the
cassette is closed.
That start ID is erased.
The ERASE indicator flashes while the start
ID is detected. While the start ID is being
erased, the ERASE indicator lights and the
START ID indicator flashes.
If you press the START ID ERASE
button during the stop mode or
while the START ID indicator is not
on the display
The start ID just before the current position
is erased.
When a start ID is erased
If a program number is also written with the
start ID, the program number will be
erased as well at the same time and the
succeeding program number remain
unchanged. In this case, re-arrange the
program number with the renumbering
function. (Page 36.)
During playback, press the START
ID WRITE button where the start ID
to be shifted is written.
Perform steps 2 and 3 described,
"Writing Manually during
Playback."
33