Introduction NOTE: Refer to the equipment’s rating plate to ensure that the plug and fusing are suitable for Thank you for purchasing this piece of the voltage and wattage stated. Cole-Parmer equipment. To get the best The wires in the mains cable are coloured as performance from the equipment and for your follows: own safety, please read these instructions...
Digital Temperature Display Control Temperature Control Switch Fault Load Indicator Indicator Fault Load Indicator Indicator Pre-set Mains Pre-set Mains Temperature On/Off Temperature On/Off Figure 1: INC-200 controls Figure 2: INC-200D controls General Description Pre-set Temperature Switch: This is a rocker-type The INC-200 and INC-200D incubators are switch.
Figure 3: INC-200 & INC-200D assembly Assembly List of components Refer to Figure 1 Fasten the 4 hinge bars to panels using x2 M4 control panel (right hand side) screws to each hinge component. Do not door panel tighten at this stage. left panel 2.
Operation Only spare parts supplied or specified by Antylia Scientific or its agents should be used. Fitting of 1. Position the apparatus on a firm level surface non-approved parts may affect the performance away from any heat sensitive material and of the safety features designed into the switch the unit ON.
Technical Specification INC-200 & INC-200D Temperature range Ambient +5ºC to 60ºC Temperature fluctuation at 37ºC ±0.1ºC Temperature variation between shelves ±0.3ºC Nominal volume 60 litres Internal dimensions (w x d x h) 450 x 380 x 380mm External Dimensions (w x d x h) 600 x 390 x 390mm Net Weight 11.2kg...
Page 7
This product meets the applicable CE Directives that interference will not occur in practise. Where and UKCA Legislation for radio frequency there is a possibility that injury, damage or loss might interference and may be expected not to occur if equipment malfunctions due to radio interfere with, or be affected by, other equipment with similar frequency interference, or for general advise before qualifications.