Table of Contents
Advertisement
Introduction
Thank you for purchasing this piece of
Cole-Parmer equipment. To get the best
performance from the equipment and for your
own safety, please read these instructions
carefully before use. Before discarding the
packaging check that all parts are present and
correct.
This equipment is designed to operate under the
following conditions:
❖ For indoor use only
❖ Use in a well ventilated area
❖ Ambient temperature range +5ºC to +40ºC
❖ Altitude to 2000m
❖ Relative humidity not exceeding 80%
❖ Mains supply fluctuation not exceeding 10%
❖ Over-voltage category II IEC60364-4-443
❖ Pollution degree 2
If the equipment is not used in the manner
described in this manual and with accessories
other than those recommended by Antylia
Scientific, the protection provided may be
impaired.
Electrical Installation
THIS EQUIPMENT MUST BE EARTHED
Before connection please ensure that the line supply
corresponds to that shown on the rating plate.
Model
Supply requirements
INC-200
220-240V, 50Hz
INC-200D
220-240V, 50Hz
All models are supplied with two mains leads
fitted with IEC plugs for connection to the
instrument. One has a U.K. 3 pin plug and the
other has a 2 pin "Schuko" plug for connection
to the mains. Choose the lead appropriate for
your electrical installation and discard the other.
Should neither lead be suitable, take the lead
with the U.K. plug and replace the plug with a
suitable alternative. This involves cutting off the
moulded plug, preparing the cable and
connecting to the re-wireable plug in accordance
with its instructions.
THIS OPERATION SHOULD ONLY BE UNDERTAKEN BY A
QUALIFIED ELECTRICIAN
NOTE: Refer to the equipment's rating plate to
ensure that the plug and fusing are suitable for
the voltage and wattage stated.
The wires in the mains cable are coloured as
follows:
BROWN
BLUE
GREEN/YELLOW - EARTH
The instruments are fitted with an IEC socket at
the rear of the instrument for connection of the
mains lead. The appropriate mains lead should
be connected BEFORE connection to the mains
supply.
Should the mains lead need replacement, a cable
of 1mm
to an IEC320 plug should be used.
IF IN DOUBT CONSULT A QUALIFIED ELECTRICIAN
Safety Advice Before Use
❖ The unit should be carried with both hands,
❖ Never move or carry the unit while it is in use
❖ Do not mix flammable liquids or use the
❖ In case of mains interruption, a fault or
❖ Mechanical energy can lead to breakage of
❖ Do not position the unit such that it is
Power
350W
350W
- LIVE
- NEUTRAL
of harmonised code H05W-F connected
2
with fingers under each side of the frame.
or connected to the mains supply.
equipment in hazardous atmospheres.
mechanical failure, the unit will continue to
operate on removal of fault.
glass vessels. Use with care.
difficult to disconnect it from the mains by
removing the mains cable from the socket at
the back.
USE CAUTION WHEN REMOVING VESSELS
FROM THE INCUBATOR AS PARTS MAY BE HOT.
Advertisement
Table of Contents
