Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Cole Parmer Stuart SI60
Summary of Contents for Cole Parmer Stuart SI60
- Page 1 Incubator SI60 and SI60D Instruction Manual Version 1.2...
-
Page 2: Electrical Installation
Introduction NOTE: Refer to the equipment’s rating plate to ensure that the plug and fusing are suitable for Thank you for purchasing this piece of Stuart the voltage and wattage stated. equipment. To get the best performance from The wires in the mains cable are coloured as the equipment and for your own safety, please follows: read these instructions carefully before use. -
Page 3: General Description
Digital Temperature Display Control Temperature Control Switch Fault Load Indicator Indicator Fault Load Indicator Indicator Pre-set Mains Pre-set Mains Temperature On/Off Temperature On/Off Figure 1: SI60 controls Figure 2: SI60D controls General Description Pre-set Temperature Switch: This is a The SI60 and SI60D incubators are constructed rocker-type switch. -
Page 4: List Of Components
Figure 3: SI60 & SI60D assembly Assembly List of components Refer to Figure 1 control panel (right hand side) door panel Fasten the 4 hinge bars to panels using x2 M4 screws to each hinge component. Do not left panel tighten at this stage. -
Page 5: Operation
Operation Only spare parts supplied or specified by Cole-Parmer or its agents should be used. Fitting 1. Position the apparatus on a firm level surface of non-approved parts may affect the away from any heat sensitive material and performance of the safety features designed into switch the unit ON. -
Page 6: Technical Specification
Technical Specification SI60 & SI60D Temperature range Ambient +5ºC to 60ºC Temperature fluctuation at 37ºC ±0.1ºC Temperature variation between shelves ±0.3ºC Nominal volume 60 litres Internal dimensions (w x d x h) 450 x 380 x 380mm External Dimensions (w x d x h) 600 x 390 x 390mm Net Weight 11.2kg... - Page 7 This product meets applicable and so we cannot guarantee that interference will not harmonized standards for radio frequency occur in practice. Where there is a possibility that injury, interference and may be expected not to damage or loss might occur if equipment malfunctions interfere with, or be affected by, other equipment with due to radio frequency interference, or for general similar qualifications.
- Page 8 Cole-Parmer Ltd. Beacon Road, Stone, Staffordshire, ST15 0SA, United Kingdom Tel: +44 (0)1785 812121 Email: cpinfo@coleparmer.com Web: www.stuart-equipment.com...
Need help?
Do you have a question about the Stuart SI60 and is the answer not in the manual?
Questions and answers