Table of Contents
Advertisement
Figure 3: INC-200 & INC-200D assembly
Assembly
Refer to Figure 1
1.
Fasten the 4 hinge bars to panels using x2 M4
screws to each hinge component. Do not
tighten at this stage.
2. Attach the handle to front door using x5 M4 screws.
3. Screw the countersunk metal screw and washer
into the bottom of the front panel.
4. Connect the 2 door clips to the front of the side
panels with x2 M3 screws and x2 dome nuts for
each clip.
5. Fasten the tie bar with x2 M4 screws at each
end. The unit should now be free standing with
the tie bar supporting the 2 end units.
6. Insert the hinge bars connecting the front and
back panels.
7. Squeeze some silicon compound into the
grooves on the back and top panel so when
assembled a good seal is formed.
8. Insert two side panels into back panel. Then
place top panel into position.
9. Attach door panel to top panel via hinges.
10. Insert the 4 plugs into the holes on the side panels.
11. Finally, tighten up all the screws, but do not
overtighten. Allow the silicon sealant at least 12
hours to dry before use.
List of components
x
1
control panel (right hand side)
x1
door panel
x1
left panel
x1
top panel
x1
back panel
x1
tie bar
x1
door handle
x1
tube of silicon rubber compound
x4
hinges
x2
hinge bars
x4
plugs
x2
door clips
x1
magnet catcher
x1
countersunk screw & washer
x4
dome nuts
x4
M3 screws
x17 M4 screws
Advertisement
Table of Contents
