Table of Contents
Advertisement
[ENG] NetPing Light Sensor 813S2, User guide -[ENG] [813S2] 5. Connection to actuators and initial setup.
Sensor terminal
3
•
White — normally open N.O. (open) contact;
•
Black wire - common;
•
Red — sensor power + 5V.
Installation and connection
The light sensor can be mounted on a horizontal or vertical surface.
The device has outputs of the "dry contact" type with a normally open contact and is connected to NetPing devices
like all sensors of this type.
When installing the sensor, the following restrictions must be taken into account:
•
Do not install the device near heat sources.
•
Do not open the device case.
•
Avoid getting liquid on the sensor, in particular in the connectors.
The length of the loop from the sensor to the caste device should not exceed 100 m. If necessary, the length of the
native loop can be increased by an extension cable of the
with a cross section of at least 0.4 mm2.
Important! When used in conjunction with devices with combined I/O contacts, the corresponding IO line
to which the signal wire from the sensor is connected must be switched to the "input" mode in the device
settings.
Connection steps
Step 1.
Connect the sensor to the device.
Sensor Loop (coloured)
Red - +5 V
Cable 4 extender, 4m
Device terminal
+5V
Or independently using any wire
[ENG] [813S2] 5. Connection to actuators and initial setup.
–
Advertisement
Table of Contents
