[Eng] [995S2] Installation And Connection; Connection Order - NetPing 995S2 User Manual

[ENG] [995S2] Installation and Connection

The supply voltage sensor can be installed on a horizontal or vertical surface. Mounting holes are not provided.
When you install the device, the following restrictions must be considered:
• Do not expose the device to direct sunlight.
• Do not install the device close to any heat sources.
• Do not open the case of the device.
• Avoid getting liquid on the sensor, particularly in the connectors.

Connection Order

Step 1.
Connect the sensor to the device and the power supply. The connection order does is not important, the sensor has
galvanic isolation.
When you connect the sensor, it is recommended to disconnect the monitoring device/power control of the
device from the mains supply (IP PDU).
• the black wire — common;
• the white wire — normally opened (break) contact
• the red wire — normally closed (live) contact
[ENG] NetPing Supply Voltage Sensor 995S2, User guide -[ENG] [995S2] Installation and Connection
[ENG] [995S2] Installation and Connection
–