Step 2; Setting; Step 1 - NetPing 813S2 User Manual

[ENG] NetPing Light Sensor 813S2, User guide -[ENG] [813S2] 5. Connection to actuators and initial setup.
For detailed information on connecting this sensor to the connected device, see the manual of the tail device in the
section "Connecting devices of the "Dry contact" type.

Step 2.

Go to the web interface of the monitoring device to start configuration. The sensor configuration in
the device's web interface is specified in the description of the firmware, the section "Working with discrete I/O
channels" for the corresponding model
here: www.netpingdevice.com

Setting

Step 1.

With a 2.5 mm slotted screwdriver, adjust the position of the SW group switches and select one of the three ranges
according to the table:
SW1
X
ON
X
SW2
X
X
ON
Range
10-70 LUX
100-700 LUX
1000-7000 LUX
[ENG] [813S2] 5. Connection to actuators and initial setup.
–