Hardware Description; Cysbsyskit-Dev-01; Baseboard Components - Infineon XENSIV CSK PAS CO2 User Manual

Table of Contents

Advertisement

User Guide for XENSIV™ KIT PAS CO2

Hardware description

5
Hardware description
This chapter introduces you to various features of the XENSIV™ KIT PAS CO2. Firstly, CYSBSYSKIT-DEV-01 and its
components are described. Secondly, XENSIV™ PAS CO2 wing and its components are described.
5.1

CYSBSYSKIT-DEV-01

5.1.1

Baseboard components

The Rapid IoT connect developer kit is designed for evaluation of the CYSBSYS-RP01 Rapid IoT connect module
on a form factor that is compatible with Breadboard and Feather wings. The CYSBSYS-RP01 SoM is a turnkey
module that enables secure, scalable, and reliable compute and connect. It has all hardware resources of PSoC™
6 MCU including Cortex®-M0+ and Cortex®-M4 cores available for the user. Please note that Cortex® M0+ will be
used as network processor if you intend to use Infineon® Rapid IoT cloud platform and Subsystem
Communication Layer for IoT Services.
The Rapid IoT connect developer kit contains CYSBSYS-RP01 Rapid IoT connect module with 512-Mbit SPI NOR
Flash, Optiga Trust M Secure controller, NTC thermistor, reset button, user button, user LED, on-board
programmer/debugger (KitProg3) along with USB-UART interface and USB-I2C interface in a compact form factor
with stackable headers containing 1 SPI Interface, 1 UART interface, 1 I2C interface and 14 GPIOs where 6 pins
can be configured as ADC as well. Apart from these, it also contains various power circuitry such as single cell Li-
Po battery charger, buck-boost converter, LDOs, load switches, etc.
Li-Po Battery
2.9~4.2V
3.7 V
@350mAh
USB Micro-B
5V
Connector
5V
D+,D-
10-pin SWD/
Connector
SWD, XRES
KITProg3
CY8C5868LTI
5-Pin KP3
Mode
Status
Programming
Button
LED
Header
Hardware block diagram
Figure 25
Power/
Battery
Charging
connector
LED(x2)
2.9~4.2V
Li-Po Battery
2.8~4.7V
Charger
BQ24074RGTT
Super Cap
DSK-3R3H224U-HL
0 Ohm
3.6V
JTAG
Jumper
3.3V,1.8V
VBACKUP
SWD,JTAG, XRES
@3.3V
I2C,UART
@3.3V
Level
Translator
For RTS/CTS
Reset Button
User Button
Buck/Boost
converter
3.6V
RT6158AWSC /
EN
TPS63027YFFR /
ISL91110AZ
3.3V/1.8V
3.3V
I2C
CYSBSYS-RP01
EN
24 of 54
Radio VDDIO
/MCU VDDD,
1.8V
VDDIO0
1V8 LDO
TPS7A2518DRVR
3.3V
0 Ohm
3V3 LDO
Jumper
TPS7A2533DRVR
VDDUSB
QSPI Flash
S25FL512SAGBHI
A13
OPTIGA
Infineon Devices
Trust M
DNI Devices
User LED
Thermistor
Expansion
Headers
MCU
VDDA/
VDDIO1
2022-25-04

Advertisement

Table of Contents
loading

Table of Contents