Fujitsu PRIMERGY RX2520 M5 Upgrade And Maintenance Manual page 457

# of Description
Beep
1 Invalid password
5 No Console Input
devices
2
devices
6 Flash update is failed
8 Platform PCI resource
requirements cannot be
met
RX2520 M5
1
or Output
are found
Upgrade and Maintenance Manual
Action
▶ Check for the correct password and try
again. Make sure that the caps lock key
is deactivated.
Booting will continue.
1
Serial console redirection is considered
a console output device if enabled.
2
Serial console redirection is considered
a console input device if enabled.
This beep code is only an information.
A processing bar and an error message is
displayed on the screen.
This beep code is only an information.
▶ Check the connection of your
expansion card whether it is installed in
a correct slot.
▶ Enter the BIOS setup menu.
▶ Open the Advanced menu.
▶ Check in the PCI Subsystem Settings
the parameter Above 4G Decoding.
This parameter must be set to
Enabled.
Appendix A
457