(Optional) Connect A Thunderbolt 3 Peripheral; (Optional) Connect Displays - StarTech.com M2E4BTB3 User Manual

Note: Ensure the M.2 Drive is properly seated, with the pins
making full contact, before proceeding to the next step.
Gently press down on the M.2 Drive until the notch on the
5.
M.2 Drive is aligned with the hole for the Holding Screw.
While holding the M.2 Drive in place, secure the M.2 Drive
6.
by replacing the Holding Screw that was removed in step 3,
using a Phillips Head Screwdriver.
Repeat steps 3-6 to instal the remaining M.2 Drives.
7.
Replace the Drive Bay Cover that was removed in step 2.
8.
Screw in the two Drive Bay Screws that were removed in
9.
step one, using a Phillips Head Screwdriver.

(Optional) Connect a Thunderbolt 3 Peripheral

Connect a Thunderbolt 3 Cable (sold separately) to one
•
of the Thunderbolt 3 Ports on the Enclosure and to a
Thunderbolt 3 Port on the Thunderbolt 3 Peripheral.
--Or--
Connect a Thunderbolt 3 Peripheral directly to one of the
•
Thunderbolt 3 Ports on the Enclosure.

(Optional) Connect Displays

Note: Connect and setup the DisplayPort Enabled
Display Device before connecting and setting up the
Thunderbolt 3 Enabled Display Device.
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
6