HOGERT HT1E601 User Manual page 16

4.2. 8. Alternating current
Range
600 mA
10 A
Overload protection: mA range fuse (FF630mA / 250V); 10A fuse (FF10A / 250V).
When the measured current is greater than 5A, the continuous measurement time must not exceed 15 seconds and it is neces-
sary to stop the current measurement for 1 minute after the measurement.
Band: 50 Hz - 400 Hz, RMS
4.2. 9. Battery measurement
Range
1.5 V
9 V
Overload protection: 250 V DC / AC
5. Battery replacement
To avoid electric shock or injury caused by an incorrect reading, replace the battery immediately when the instrument
display shows the „
check whether the testers have been disconnected from the circuit being measured.
Replace the battery according to the following steps:
1. Disconnect the power supply to the instrument.
2. Pull all test plugs out of the input socket.
3. Loosen the screws securing the battery cover.
4. Remove battery cover.
5. Remove old battery.
6. Replace with a new AAA 2 x 1.5 V battery.
7. Place the battery cover and tighten the screws.
16
Resolution Accuracy
0.1 mA ±(1% reading + 3 digits)
10 mA ±(1.5% reading + 3 digits)
Resolution
0.001 V
0.001 V
". Before opening the battery cover and replacing the batteries, it is necessary to switch off and
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków