Operating Mode Sw; Operating Mode Rm; Operating Mode Ja; Operating Modes - Nice elero Revio-868 SW Operating Instructions Manual

Operating Modes

Operating Mode RM: Jumper between RM and L
If a jumper is used between RM and L, the Revio-868 SW is in the
roller shutter/awning drive mode.
When operated via radio or connected button, the output is
switched off for 300 seconds, so that the roller shutter/awning sys-
tem can run its entire path.
Operating Mode JA: Jumper between JA and L
If a jumper is used between JA and L, the Revio-868 SW is in the
Venetian blind drive mode.
When operated via the radio or the connected button for less than
3 seconds, a Venetian blind system can be controlled in stepping
mode. If the button is pushed for more than 3 seconds, the output
is switched on for 300 seconds, so that the Venetian blind system
can run its entire path.
12 | EN
Ⓒ elero GmbH
Operating Modes
Change of the operating mode
A change between the operating modes SW / RM / JA is only pos-
sible wit the Revio-868 SW deleted completely after restart. The
following procedure must be complied with to change the operat-
ing mode:
1. Delete Revio-868 SW completely: At a programmed transmitter,
pushed the buttons UP, DOWN, STOP and P for at least 6 sec-
onds.
2. Disconnect Revio-868 SW from the supply voltage.
3. Insert jumper depending on operating mode.
4. Connect Revio-868 SW to the supply voltage.
5. Programme desired transmitter(s)
P button
Pushing the P-button for at least 1 second and re-establishing of
the mains starts the Revio-868 SW and it is then ready for pro-
gramming for 5 minutes.
Commissioning
(connection of a tubular or Venetian blind motor)
!
PREREQUISITE!
The Revio-868 SW is installed
(→ see chapter on connection of RM/JA)
The end positions must be set.
Any jumpers for Venetian blind or tubular drive that must be wired
must be wired before programming of transmitters.
1. When the power supply is restored or by pressing the P-button
(min. 5 Sec) on the Revio-868 SW, the device is ready to pro-
gramme for 5 minutes.
2. Program the transmitter (→ see transmitter instructions).
Ⓒ elero GmbH
EN | 13