Related Manuals for Nice elero Revio-868 SW
Summary of Contents for Nice elero Revio-868 SW
- Page 1 Revio-868 SW No. 28 415 0006 Operating instructions (translation) Keep the operating instructions in a safe place! 181111901_EN_0814...
-
Page 2: Table Of Contents
Table of Contents Device explanation Device Explanation ..............3 Safety Notes .................. 4 Exclusion of Liability ..............4 P-Button Scope of Delivery/General ............6 Intended Use ................. 6 Button Notes on Radio Operation ............7 connection Assembly / Connection ..............8 In ▼... -
Page 3: Exclusion Of Liability
Safety Instructions / Exclusion of Liability Safety Instructions STOP! CAUTION! Observe the following safety instructions. Observance of the operating instructions is the pre- Failure to observe them can lead to bodily injuries! requisite for disturbance-free operation and entitle- General ment for claims related to defects. •... -
Page 4: Scope Of Delivery/General
Scope of Delivery / General Notes on Radio Operation Intended use Scope of delivery CAUTION! Revio-868 SW Observe the following safety instructions for radio Operating instructions operation! Only use radio systems if they are allowed and can General information be operated without interference. The Revio-868 SW is an flush mounted radio receiver. -
Page 5: Connection Of Venetian Blind Drive
Installation / Connection Connection Installation and connection 1. Place the Revio-868 SW in the socket. 2. Connect the stripped cable ends without connector sleeves as NOTE! follows: Before installation in the required assembly position, Connection of Operating Mode SW: Tubular drive or check that the transmitter and receiver are function- electrical consumer ing properly. -
Page 6: Direction Assignment Of The Outputs
Best Use of the Radio Signal Explanation Direction Assignment of the Outputs Optimal use of the radio signal Out ▲ ▼ connection terminal for drive/lighting facility/other electrical consumers • Do not kink the aerial. The outputs are intended for the connection of a drive, lighting facil- •... -
Page 7: Operating Mode Sw
Operating Modes Operating Modes Change of the operating mode Operating Mode RM: Jumper between RM and L A change between the operating modes SW / RM / JA is only pos- If a jumper is used between RM and L, the Revio-868 SW is in the sible wit the Revio-868 SW deleted completely after restart. -
Page 8: Technical Data
Troubleshooting / Declaration of Conformity Technical Data Disposal Programming further transmitters → see transmitter instructions Dispose of the device according to the current electrical waste With multi-channel transmitters, it is not possible to use the central disposal regulations of the country concerned (e.g. suitable collec- channel. - Page 9 We reserve the right to make technical changes Ⓒ elero GmbH...