Connection Of Venetian Blind Drive; Connection Of Tubular Drive - Nice elero Revio-868 SW Operating Instructions Manual

Installation / Connection
Installation and connection
NOTE!
Before installation in the required assembly position,
check that the transmitter and receiver are function-
ing properly.
The flush-mounted socket has to be fixed so that the
drill hole does not touch any electrical lines.
Connection
You can find the structure of a controller on elero.de in the down-
load area under "Installation instructions and circuit diagrams".
WARNING!
Risk of injury due to electrocution!
• The connection must only be made by an authorized
specialist!
• The device only offers protection against touch by the
back of the hand, no protection against accidental con-
tact.
• Do not kink, shorten or extend the aerial.
• Only operate the learning buttonP with insulated tools
(4 kV voltage protection).
• Note the switching current of the device.
!
PREREQUISITE!
Flush-mounted socket Ø 58 mm, 60 mm deep.
8 | EN
Ⓒ elero GmbH
Connection
1. Place the Revio-868 SW in the socket.
2. Connect the stripped cable ends without connector sleeves as
follows:
Connection of Operating Mode SW: Tubular drive or

Connection of Venetian Blind Drive

Connection of Tubular Drive

Ⓒ elero GmbH
electrical consumer
EN | 9