Table of Contents
Advertisement
Best Use of the Radio Signal
Direction Assignment of the Outputs
Optimal use of the radio signal
• Do not kink the aerial.
• Do not shorten or extend the aerial.
• If reception is poor, adjust the antenna. position
• Install the antenna so that it is as exposed as possible.
• Antenna is not to rest on metal.
NOTE!
Radio systems, which operate on the same frequen-
cy, can lead to reception of interferences.
Please note, that the range of the radio signal is lim-
ited by the government and the built environment.
Direction Assignment of the Outputs
After the drive is connected, check the direction assignment of the
outputs.
The first automatic run in programming mode must take place in
the UP or retraction direction.
If this is not the case, swap the connections at the outputs.
10 | EN
Ⓒ elero GmbH
Explanation
Out ▲ ▼ connection terminal for drive/lighting facility/other
electrical consumers
The outputs are intended for the connection of a drive, lighting facil-
ity or other electrical consumer.
The arrows indicate the running direction of the drive or the switch-
ing of the output regarding the direction button of the transmitter.
▲ Retract connection for hanging
▼ Extend connection for hanging
When connecting a Venetian blind or a tubular motor, the running
direction of the hanging is to match the icons ▲▼.
For connection of a lighting facility or other electric consumer, the
two terminals can be connected to each other so that the load can
be switched on with the UP button as well as the DOWN button and
is switched off with the STOP button.
IN ▼ ▲ connection terminal for button
Connection terminals for a Venetian blind button, which corresponds
to a mutually locked button. A button push of less than 300 ms (mil-
lisecond) at the external venetian blind button leads to a stop. If a
button is pushed for an extended period, a running movement is
started according to those of the operating mode of the
Revio-868 SW.
Operating Modes
Operating mode SW: no jumper
(electrical consumer)
Function: Activation times of the UP/DOWN outputs are not limited,
i.e. the relays do not switch off on their own.
• Output switches to self-maintenance at once with the UP/DOWN
button
• Automatic turn at the end of the run if the shading position and
the turning position is defined.
Ⓒ elero GmbH
EN | 11
Advertisement
Table of Contents
