Table of Contents
Advertisement
CPI Satcom & Antenna Technologies
STEP 3:
Fine Azimuth Adjustment:
adjustments in azimuth can be made by loosening the three Locking Hex
Nuts on the underside of the Canister top plate of the Az/el Positioner
and the two hex nuts under the Azimuth Pivot Posts.
With this hardware loosened, adjustments in azimuth can be made by
turning the Azimuth Adjust Bolt at the back of the Az/El Positioner in either
direction. See Figure 3-3.
Note: Azimuth Adjust Rod is for adjustment only, it is not intended to
be part of the structural integrity of the assembly, therefore
"tightening" the Azimuth Adjust Bolt is not necessary.
Azimuth Adjust Bolt
Azimuth Pivot Post
Hex Nuts
(2 Places)
Locking Hex Nuts
(3 Places)
STEP 4:
Peak the antenna signal by fine adjustments made in both Azimuth and
Elevation until the optimum signal is achieved.
STEP 5:
Securely tighten all hardware used for adjustment.
Once the target satellite is located, fine
Figure 3-3
13
1.2M Ku-BAND SERIES 1122
4096-1000
Advertisement
Table of Contents
