NEC SL2100 Hardware Manual page 151

ISSUE 4.0
These procedures refer to items on the back of the DTL-RPT-2 Repeater:
Figure 2-154 Back View of the DTL-RPT-2 Repeater
During registration, the LED on the front of the repeater will blink. The table explains what the LED
blink patterns indicate.
State
Steady On
Slow blink (one blink per second)
Flicker (2 rapid blinks per second)
INSTALLING WIRELESS DECT TELEPHONES
Table 2-37 Repeater LED Patterns
The repeater is registered to a base and has a good signal from that base (or an-
other repeater registered to that base).
Standby mode. The repeater is not registered or cannot be connected to the regis-
tered base.
The repeater is in registration mode (it is looking for a base to register to).
Meaning
SL2100
149