Specifications - PowerTec Regenerative Brushless DC Motor Control 1000AR Installation And Operation Instruction Manual

2
Page
S P E C I F I C ATI O N S
E n v i r o n m e n t a l
ALTITUDE :
STORAGE TEMPERATURE :
AMBIENT TEMPERATURE :
Chassis :
Nema1 :
RELATIVE HUMIDITY :
POWER SOURCE :
Voltage :
Voltage Tolerance :
Phases :
Frequency :
KVA Required :
Max KVA Rating :
D i m e n s i o n s
Physical Dimensions :
Approximate Weights :
1000AR chassis :
1000AR Nema1 :
P e r f o r m a n c e
Maximum Load :
Speed Regulation :
Speed Accuracy :
Analog Mode :
Linearity :
Digital Mode :
Displacement power factor :
Ad j u s t m e n t s
ACCELERATION TIME :
DECELERATION TIME :
MAXIMUM SPEED :
MINIMUM SPEED :
JOG SPEED :
CURRENT LIMIT :
GAIN :
STABILITY :
J u m p e r s
L E D I n d i c a t o r s
T e r m i n a l As s i g n m e n t s
1000AR
Model Installation and Operation Manual
Use above 3300 feet (1000 meters) requires de-rating.
De-rate at 3% of full rating for each additional 1100 feet (330 meters).
-40 °C to +65 °C (-40 °F to + 150 °F)
Maximum air temperature of 55 °C (131 °F).
Maximum air temperature of 40 °C (104 °F).
Less than 95%, non-condensing.
Nominal 230 VAC, 380 VAC, or 460 VAC per nameplate rating.
-10%, +10% of nominal rated voltage.
Three (Drive will not operate on single phase).
48 to 62 Hertz
KVA rating of source must be at least equal to Horsepower rating.
100 KVA (limited by input fuse AIC rating).
See page 8.
75 pounds ( 34 kg ).
110 pounds ( 50 kg )
150% for 1 minute out of 10 minutes.
0.0% (on load change from no load to full load)
+/- 1.0% typical with speed pot supplied by internal reference.
+/- 0.5% typical with external reference source.
0.0 % typical ( +/- ¾ revolution of the motor shaft ).
0.96 typical
2 to 90 seconds with JP2 installed; 0.05 to 2 seconds with JP2 removed..
2 to 90 seconds with JP2 installed; 0.05 to 2 seconds with JP2 removed..
Acceleration and deceleration times settable in analog mode only.
600 to 5000 RPM ( motor dependent ), analog mode only.
0 to 15% of MAXIMUM SPEED with 5K speed potentiometer, analog mode only.
0 to 30% of MAXIMUM SPEED, analog mode only.
Adjustable from 0% to 150% of rated current, calibrated by Horsepower Resistor.
10 to 1 stiffness ratio
20 to 1 dynamic response.
S e e P a g e 3 2
S e e P a g e 3 6
S e e P a g e 2 2
6/4/2001 © copyright 1997 by Powertec