Advertisement
R. PRE-PROGRAMMED HEAT RECOVERY SCENARIOS
There are 16 preprogrammed sceanarios embedded to electronical card;
1. Standard Heat Recovery
2. Heat Recovery with 3 Steps Electrical Heater (With Fresh Air Damper)
3. Heat Recovery with 3 Steps Electrical Heater (With By-Pass Damper)
4. Advanced Heat Recovery with 3 Steps Electrical Heater (With Fresh Air Damper)
5. Heat Recovery with 1 Step Pre-Heater 2 Step After Heater
6. Heat Recovery with 2 Steps Pre Heater 1 Step After Heater
7. Heat Recovery with 3 Steps Pre Heater
8. Heat Recovery with Poportional Valved Water Coil (2Pipe)
9. Heat Recovery with Poportional Valved Water Coil (2Pipe)
10. Heat Recovery with heat pump
11. Heat Recovery with advanced heat pump
12. Heat Recovery with Dx Coil(VRF)
13. Heat Recovery with On/Off Valved Water coil(4Pipe)
14. Heat Recovery with EC Fan and 3 Steps Electrical Heater
15. Heat Recovery with EC Fan and On/Off Valved Water Coil (2Pipe)
16. Heat Recovery with EC Fan and On/Off Valved Water Coil (4Pipe)
S. CHANGING THE SCENARIOS
To change the scenario;:
.
•
When the unit is connected to power supply , press
Enter service menu password "58"by using
•
Go parameter ''480'' by using
•
•
Change the number to desires scenario(above list (1-16) by using
•
Check out from the menu by using
•
When the unit is on manual heating,manual cooling or fan mode , fan steps and and set tempearture can be
adjusted. In manual mode, when in set temperature screen, if you press
scenario.
•
When the unit is in auto mode, switching to next mode will be done by presing
UP
UP
and
DOWN
UP
and
DOWN
and press Mode/OK.
ON/OFF
button
and
DOWN
buttons simultaneously
and press Mode/OK.
UP
and
DOWN
and press Mode/OK.
Mode/OK
Mode/OK
then it will switch to next
Advertisement
