Error Codes Trouble Shooting - Jakka CONTROL KIT 5 User Manual

N.

ERROR CODES TROUBLE SHOOTING

CODE EXPLANATION
E 0001 Exhaust Fan Error
E 0002 Supply Fan Error
E 0004 Electrical Heater Error
E 0008 Exhaust Air Flow Error
E 0016 Supply Air Flow Error
E 0099 Connection Error between
Controller and Card
E 0256 Fire Alarm
Check the fan,connection cables and filter.If 11lla re fine,
reset the alarm by pressing
simultaneously If there is a broken component replace it
with a new one.
Check the fan,connection cables and filter.If 11lla re fine,
reset the alarm by pressing
simultaneously If there is a broken component replace it
with a new one.
Check the electrical heater and connection cables ..If 11lla
re fine, reset the alarm by pressing
simultaneously If there is a broken component replace it
with a new one.
Check the exhaust fan,connection cables ,filter and
ducting..If 11lla re fine, reset the alarm by pressing
and UP buttons simultaneously If there is a broken
component replace it with a new one.If there is an
obstacle at the duct systemi, clean it a for a better air
flow.
Check the exhaust fan,connection cables ,filter and
ducting..If 11lla re fine, reset the alarm by pressing
and UP buttons simultaneously If there is a broken
component replace it with a new one.If there is an
obstacle at the duct systemi, clean it a for a better air
flow.
Check connection cables between controller and the
board
Check if there is fire or not.. If the alarm is because of a heat
transmitter close to room thermostate , or another factor that
increases the temperature at the room artificially, make sure
that the room thermostate reads the temperature at the normal
conditions. Also check the electrical heater at the duct system.
If everything is controlled then reset the alarm by pressing
and UP buttons simultaneously.
FAN and UP buttons
FAN and UP buttons
FAN and UP buttons
FAN
FAN
FAN