Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Total TG111165
Summary of Contents for Total TG111165
- Page 1 HAMMER DRILL...
-
Page 2: Security Instructions
Security instructions Caution Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire, and/or serious injury. This manual must accompany the equipment at all times and must be kept in a safe place to be available. Note: Save all warnings and instructions for future reference. - Page 3 4) Use and care of power tools a. Do not force the tool. Use the correct power tool for each use. b. Do not use the power tool if its power switch does not work. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
-
Page 4: Additional Security Warnings
Additional security warnings • Wear ear protectors. Exposure to noise can cause hearing loss. • Use auxiliary handles, if supplied with the tool. Loss of control can cause personal injury. Hold power tool by insulated gripping surfaces when performing an operation •... -
Page 5: Technical Data
Technical data Data sheet Power 1050W Voltage 220-240V Frequency 50/60Hz No load speed 0-1100min-1, 0-3000min-1 Strokes per minute 0-17600min-1, 0 -48000min-1 Chuck capacity 3-16mm Metal drilling capacity 16mm Masonry drilling capacity 20mm Wood drilling capacity 40mm Weight 3.7kg Protection class 1 auxiliary handle 1 set of carbon brushes Accessories... - Page 6 Set up Installation of the auxiliary handle Loosen the handle locking screw counterclockwise. • Slide handle over neck of tool. • Rotate handle around neck to desired position. • Tighten the locking screw clockwise to fix the handle. • If you are right handed adjust the handle as shown in the picture. If you are left- •...
- Page 7 Insert the drill/tool and firmly tighten the chuck by turning the key clockwise. • Remove the wrench and replace it in the storage tab at the base of the drill • handle. Turn the chuck key clockwise to tighten ON/OFF switch operation Press the on/off switch to use the tool.
- Page 8 Change the direction of rotation • To change the direction of rotation, push the forward/reverse selector switch to the "R" position indicated on your drill. Rotation will now be forward. • Push the forward/reverse selector switch to the indicated "L" position on your drill. •...
-
Page 9: Maintenance And Troubleshooting
Working tips for your drill 1) Masonry and concrete drilling: a. Place the drill/impact action selector switch in the "hammer symbol" position. 2) drill steel a. Place the drill/impact action selector switch in the "drill symbol" (drill) position. HSS bits should always be used for drilling steel at a lower speed. -
Page 10: Exploded View
Environment • Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact your local authority for information on available collection systems. • If electrical appliances are disposed of in landfills, hazardous substances can • seep into the groundwater and enter the food chain, harming your health and well-being. -
Page 11: Hammer Drill
HAMMER DRILL...
Need help?
Do you have a question about the TG111165 and is the answer not in the manual?
Questions and answers