Dmx Addressing - ADJ VIZI WASH Z19 User Manual

D M X A D D R E S S I N G
All fixtures should be given a DMX starting address when using a DMX controller, so the correct fixture
responds to the correct control signal. This digital starting address is the channel number from which
the fixture starts to "listen" to the digital control signal sent out from the DMX controller. The assignment
of this starting DMX address is achieved by setting the correct DMX address on the digital control
display on the fixture.
You can set the same starting address for all fixtures or a group of fixtures, or set different addresses for
each individual fixture. Setting all fixtures to the same DMX address will cause all fixtures to react in the
same way, in other words, changing the settings of one channel will affect all the fixtures simultaneously.
If you set each fixture to a different DMX address, each unit will start to "listen" to the channel number
you have set, based on the quantity of DMX channels of each fixture. That means changing the settings
of one channel will only affect the selected fixture.
In the case of the Vizi Wash Z19, when in 13 Channel you should set the starting DMX address of the
first unit to 1, the second unit to 14 (13 + 1), the third unit to 27 (14 + 13), and so on. (See the charts
below for more details.)
Channel Mode
13 Channels
14 Channels
17 Channels
18 Channels
29 Channels
30 Channels
45 Channels
46 Channels
Unit 1
Unit 2 Address
Address
1
1
1
1
1
1
1
1
Unit 3 Address
14 27
15 29
18 35
19 37
30 59
31 61
46 91
47 93
16
Unit 4 Address
40
43
52
55
88
91
136
139