Advertisement
Quick Installation Guide
1
LOCATE CORRECT SITING POINT
ALARM SHOULD BE CEILING MOUNTED AT LEAST 300mm FROM
WALLS & OBSTRUCTIONS, IDEALLY CENTRALLY IN ROOM/AREA
2
FIX & WIRE MOUNTING PLATE
WIRE TO TERMINALS ON THE MOUNTING PLATE AND FIX
MOUNTING PLATE TO CEILING USING THE FIXINGS PROVIDED
3
SLIDE ON ALARM
SLIDE ALARM ONTO MOUNTING PLATE. A CLICK SHOULD
BE HEARD AS THE TAMPER-PROOF CATCH ENGAGES
4
TEST ALARMS
PRESS AND HOLD THE TEST BUTTON ON THE ALARM. THE
ALARM AND ANY OTHER INTERCONNECTED UNITS SHOULD SOUND
1. Introduction
1
LOCATE REMOVAL SLOT & INSERT SCREWDRIVER
The Ei140e series is supplied with an Easi-Fit base that
allows very quick and simple installation of the Smoke
Alarm, combined with simple detector head removal
and replacement. The Easi-Fit base automatically
connects both mains power and battery as the detector
head slides on to the Easi-Fit base.
Up to 12 Smoke/Heat Alarms can be interconnected so
that when one senses fire all the units alarm.
LOCATE THE ARROW ON THE FRONT FACE OF THE ALARM
Interconnection can be achieved by hardwire or through
THE SLOT IS LOCATED DIRECTLY ABOVE THE ARROW
an RF mounting plate, the Ei168RC.
INSERT A FLAT-BLADED SCREWDRIVER HORIZONTALLY
APPROX. 1cm INTO THE CENTRE OF THE REMOVAL SLOT
All Alarms feature a combined test/hush button.
2
SLIDE ALARM OFF BASE & REMOVE ALARM
Installer Section
Alarm Removal
2
Advertisement
