Table of Contents
Advertisement
5. OPERATING INSTRUCTIONS
WARNING!
This unit is intended to be used with cold water only! Do not use hot water in this pressure cleaner!
WARNING!
High pressure hose must not loop.
During operation the appliance must be positioned on a firm and stable surface.
5.1 STARTING UP
WARNING!
ALWAYS turn off the unit's motor BEFORE turning off the unit's water supply.
Serious damage could occur to the motor if the unit is run without water.
a) Turn on the water supply tap fully.
b) Unlock trigger (by pressing the safety button first and then actuate the trigger) for a few second; let the
water flow out from the nozzle.
c) Check if water leaks from joints. If water leaks, please reconnect the water hose, the spray gun or the lance
to make sure each accessory is connected perfectly.
d) Connect to power supply.
e) Set the power switch at the position «ON/I». (Fig.5)
f) Push the trigger and start the washer.
WARNING!
Check that the supply voltage and frequency correspond to those specified on the appliance data plate.The
appliance should only be connected to a main power supply via a security breaker (Max.30mA) to cut off the
electricity supply in the instance of a short circuit.
5.2 STOPPING THE WASHER
WARNING!
ALWAYS turn off the unit's motor BEFORE turning off the unit's water supply. Serious damage could occur to
the motor if the unit is run without water.
a) Release the trigger, the motor will stop operation.
b) Set the switch at the position OFF. (Fig.5)
c) Disconnect the plug from the socket.
WARNING!
Failure to follow the above instructions may cause damage to the machine.
17
Advertisement
Table of Contents
