Table of Contents
Advertisement
STEP 4
At the rear of the machine, remove the plastic cap, which is inserted over the male connector of the pressure
washer before shipping. This plastic cap can be discarded once removed. Then screw the water inlet connector
to the male connector. Then connect the garden hose. The recommended length for the water supply hose is 8
meters with a diameter less than 1/2 inch to prevent back pressure and any potential damage to your appliance.
Make sure it can withstand the water and at a maximum pressure of 10 bar (1 Mpa). If you want to connect your
device to other water sources, make sure that the maximum water inlet pressure is 10 bar (1 Mpa).
STEP 5
a. Extension wand
Insert the extension (8) into the gun (9). Push and turn the extension (8) clockwise on the gun (9). When the
parts are properly assembled, you cannot separate the two components. To remove the extension, turn it
and remove it from the gun.
b. Nozzle
Insert the desired nozzle into the extension, and turn it to lock it. Only one nozzle can be inserted in the
extension. Use the right nozzle for the job you want to do.
Push the unlocking button located on the gun to unlock and remove the adjustable nozzle.
c. Patio brush
-
Install the extension wand as described above.
-
Insert the patio brush in the extension wand and turn it clockwise to lock it. Push the unlocking button
located on the gun to unlock and remove the accessory.
d. Detergent Bottle
Insert the detergent bottle (14) into the gun (9). Push and turn the detergent bottle (14) clockwise onto the
gun (9) until hand tight to lock it in place. When the pieces are joined properly, you cannot separate the two
components by pulling straight out on the gun (9)
16
Advertisement
Table of Contents
