Information For Usage - Energizer EZN1600 User Manual

6. INFORMATION FOR USAGE

6.1 SAFETY VALVE AND/OR PRESSURE LIMITING VALVE
WARNING!
Do not tamper with or adjust the safety valve setting.
The safety valve is also a pressure limiting valve. When the gun trigger is released, the valve opens,
pressure switch action, the machine automatically shut down.
If the gun nozzle is blocked, it will cause the machine pressure to rise, the safety valve opens, the
pressure switch action, the machine automatically shut down, you can refer to the following point 7 to use
a needle to clean the nozzle.
6.2 AUTOMATIC ON/OFF
The pressure cleaner is equipped with an automatic on/off switch. The pressure cleaner will only run
when the power switch is in the ON position and the trigger on the gun is squeezed. When you release
the trigger to stop spraying water through the gun, the motor on the pressure cleaner will automatically
shut off. Simply squeeze the trigger again to resume using the cleaner. To stop using the pressure cleaner,
release the trigger and switch the unit to the OFF position. The unit should be turned completely OFF
while not in use or while unattended.
6.3 BLEEDING THE GUN
It is very important to bleed the gun before using the pressure cleaner. Refer to the "Assembly
Instructions" to assemble the pressure cleaner. To bleed the gun, simply connect the garden hose to the
pressure cleaner and squeeze the trigger BEFORE turning the electrical supply on. This allows any air
trapped inside the pressure cleaner and gun to be removed before using the unit. Continue holding the
trigger for approximately one minute to allow any excess air out of the unit. Water will flow through the gun
at low pressure during this procedure. For more bleeding tips, see the section titled "Operating
Instructions."
6.4 GUN SAFETY LOC
The operator should press the unlock button and then actuate the trigger to start the spray operation. When you
release the trigger, it can return to the off position automatically.
When not using the pressure cleaner, press the lock button to keep from accidentally engaging the high pressure
spray.
ORIGINAL INSTRUCTIONS >EN
19