Table of Contents
Advertisement
STEP 6
Attach the hose connector to pressure washer. Before attaching the connector to the male fitting, remove
the plastic cap, which is inserted onto the male fitting on the pressure washer before shipping. This plastic
cap can be discarded once removed. After both components have been installed, attach the garden hose
with connector screw on the pressure washer. Connect the garden hose to the waterspout.
5. OPERATING INSTRUCTIONS
WARNING!
This unit is intended to be used with cold water only! Do not use hot water in this pressure cleaner!
WARNING!
High pressure hose must not loop.
During operation the appliance must be positioned on a firm and stable surface.
5.1 STARTING UP
WARNING!
ALWAYS turn off the unit's motor BEFORE turning off the unit's water supply. Serious
damage could occur to the motor if the unit is run without water.
a) Turn on the water supply tap fully.
b) Unlock trigger (by pressing the safety button first and then actuate the trigger) for a few second; let the
water flow out from the nozzle.
c) Check if water leaks from joints. If water leaks, please reconnect the water hose, the spray gun or the
lance to make sure each accessory is connected perfectly.
d) Connect to power supply.
e) Set the power switch at the position «ON/I».(Fig.3)
f) Push the trigger and start the washer.
16
Advertisement
Table of Contents
