HDD Damper Ass'y
Make sure the product with black
sheet on the yellow sponge.
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
HDD Thermal Plate
Prepare the metal plate bend.
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Do not place the damper
over the plate of FPC.
Fold the FPC from the board edge.
HDD Ass'y
HDD Set Insert after removing the Release Paper of the two-sided tape.
Remove the Release Paper on
the back, close and attach it.
Attach it to HDD closely not to loosen.
Do not bend it at a sharp
angle to put natural R.
Longer Direction
To the level of attaching
closely in this range
When attaching HDD Cushion (Yellow) and HDD Cushion (Black),
set the bending part of the metal plate up.
1 3
Attach the HDD Cushion (Yelllow)
Attach the HDD Cushion (Yelllow)
Attach the HDD Cushion
(Black)
Sheet
7-35
Do not place the damper
over the plate of heater.
Push and bend
1 3
HDD Cushion (Black)
Metal Plate
Attach the HDD
Thermal Plate