7.2.15. Setting the GPS PCB and Bluetooth PCB
1. Fix the GPS BT Angle and GPS PCB using the 2 Screws.
<N11>
2. Connect the Cable to the Connector on GPS PCB.
3. Fix the GPS Ass'y using the 4 Screws. <N12>
4. Connect the Cable to the Connector. (CN25)
Screws <N11>: DFHE5025XA
Screws <N12>: DXQT2+F3FNL
■ Cautions for Setting GPS ASSY and BT PCB ASSY
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
S2
Safety Working
Cabinet Level Standard
Tolerance 0 to 1
Process the wire into the groove.
Safety Working
S2
Attach the Cable Sheet into
Main Cable and Whip Cable.
Ensure that the wrapping
Avoid coming over the groove.
direction is right.
Attach the Tape
Fit to the plate squeeze line. 1
8 1
10 2
Match to the boss center.
Bluetooth Cable
Whip Antenna Cable
Main Antenna Cable
<N12>
<N12>
GPS PCB
<N11>
to Connector
(CN25)
* Notes:
1. Do not gouge when inserting and removing the plug.
2. Do not damage the coating when handling the cable.
Process the wire of whip ANT cable from
LCD to the back from the aperture.
Whip Antenna Cable
Put the Cable along
the Cabinet side and
tape it firmly.
Process the wire to the
back from the aperture.
Bluetooth Cable
Pass the Cable behind
the Cabinet protrusion.
Attach the Cable Sheet into
0 2
Sub Cable and GPS Cable.
0 2
Ensure that the wrapping
direction is right.
Sub Antenna Cable
CAUTION
GPS Antenna Cable
7-31
<N12>
GPS BT Angle
<N12>
Bluetooth
PCB
<N11>
Connector(CN25)
Main Antenna
Sub Antenna
Insert the
cable plug.
GPS Antenna
Connect into the coaxial Connector.
Safety Working
S2
S1:Insulation S2:Pinching Cables S3:Sharp Edge
S4:Part No. Check S5:Others