Table of Contents
Advertisement
Quick Links
Primo Plasma Media Base
!
CAUTION
•
The top shelf of this stand is intended for use with: a Plasma/LCD/DLP/HD Television with a maximum screen size
of 41-45 inches and/or a weight of 100lbs OR a Tube Television with a maximum screen size of 14-16 inches and
weight of 35lbs. All other support shelves should not be loaded more than 25lbs.
•
DO NOT EXCEED RECOMMENDED LOAD. Use with products heavier than the maximum sizes and weight
indicated may result in instability causing possible injury.
DO NOT REMOVE THIS LABEL
04-000076-2
PRE-ASSEMBLY:
•
For your safety and ease, assembly by two adults is recommended.
•
Read all instructions before beginning assembly.
•
Remove all parts and hardware from box and lay out on a carpeted or scratch-free work surface. The shipping box
provides and ideal work surface. Do not dispose of any contents until assembly is completed to avoid accidentally
discarding small parts or hardware.
•
Do not use power drill as it may cause cracking.
PARTS INCLUDED:
A- Media Base (1pc)
B- Large Adjustable Shelf (1pc)
C- Small Adjustable Shelf (2pcs)
HARDWARE INCLUDED:
D- Screw (3/16" x 1-1/4) (2pcs)
E- Shelf Support (12pcs)
A
C
F- Knob (2pcs)
TOOLS REQUIRED (but not included):
•
Phillips Head Screwdriver
Page 1/6
www.pbteen.com
C
B
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for PB TEEN Primo Plasma Media Base
Summary of Contents for PB TEEN Primo Plasma Media Base
- Page 1 Primo Plasma Media Base CAUTION • The top shelf of this stand is intended for use with: a Plasma/LCD/DLP/HD Television with a maximum screen size of 41-45 inches and/or a weight of 100lbs OR a Tube Television with a maximum screen size of 14-16 inches and weight of 35lbs.
- Page 2 ASSEMBLY INSTRUCTIONS: 1. Attach the Knob (F) to the door by placing the Knob (F) over the pre-drilled hole on the door front, insert the Screw (D) from door interior; tighten using a Phillips Head Screwdriver as shown below. Figure 1 2.
- Page 3 3. If the media base does not sit level, loosen or tighten the adjustable levelers underneath each piece. Figure 4 CARE INSTRUCTIONS: • Dust often using a soft, dry cloth. • Do not use glass cleaner, abrasives, wax or household cleaners on wood. •...
- Page 4 Primo Plasma Media Hutch CAUTION • The top shelf of this stand is intended for use with: a Plasma/LCD/DLP/HD Television with a maximum screen size of 41-45 inches and/or a weight of 100lbs OR a Tube Television with a maximum screen size of 36-40 inches and weight of 240lbs.
- Page 5 TOOLS REQUIRED (but not included): • Power Drill ASSEMBLY INSTRUCTIONS: 1. Locate the two partially drilled holes on the interior top panel of the Media Base (A). Using a Power Drill with Drill Bit (H) bore through the partially-drilled holes holding Wood Block (I) on exterior of the top panel of the hole being drilled to prevent any breakage or damage when drilling.
- Page 6 3. Carefully place the Adjustable Shelves (B and C) onto the shelf support as shown below. Figure 3 4. Adjust the adjustable levelers on the bottom of the legs by loosening or tightening them so the Media base sits evenly on floor as shown below. Figure 4 5.
Need help?
Do you have a question about the Primo Plasma Media Base and is the answer not in the manual?
Questions and answers