Troubleshooting - HSM SECURIO C 18 Operating Instructions Manual

english

6 Troubleshooting

Note:
The safety element is fi tted with contact protection. The document shredder switches off if you
press the safety element during the shredding process.
Display Problem
Paper
jam
Continu-
ous lamp
Overload • The motor was overloaded. Let the shredder cool down for approx.
Flashing General
light fault
displays
Shredded
material
container
full
Container
open
Safety
element
pressed
14
Measure
You have fed in too much paper.
 The cutting unit runs in reverse for a few seconds and pushes the
paper back out again.
• If necessary, press the reverse button "R" to remove the stack of paper.
• Take half the stack of paper.
• Feed the paper in portions.
15 – 20 mins. before using it again.
• A fault has occurred while shedding paper.
Pull the paper out of the slot to clear the light barrier.
• Empty the shredded material container.
Note:
If you press the reverse button briefl y before removing the container,
part of the material is pulled back into the cutting apparatus and does
not fall inside the document shredder.
• Insert the shredded material container correctly in the base cabinet.
• Do not press the safety element.
SECURIO C 18
02/2021