Advertisement
OPERATING INSTRUCTIONS
SHREDDER CONTROLS
1
Shredded paper container
2
LED indicator
3
Sliding switch for operating mode
4
Safety notice
5
Feed opening for paper
6
Feed opening for CDs and cards
7
Cutting head
OPERATION
Set the sliding switch to "AUTO" for automatic mode. The "POWER" display
1.
lights up.
Insert paper into paper feed slot ⑤. Do not feed more than 10 sheets at one
2.
time. The shredder will stop after paper has passed through.
To shred a CD, DVD or credit card insert through designated slot ⑥.
3.
4.
Empty the waste bin regularly to prevent jams and damage to cutting
mechanism. Empty the CD container after shredding at least 6 CDs. To do
this, unplug the power plug and remove the cutting head. The separate CD
container is in the shredded material container.
Note: You cannot use the two cutting units at the same time. Destroy paper
and CDs/credit cards separately.
BIN FULL
Notice: Empty the cut material container immediately because if it is too full
malfunctions can occur in the cutting system.
Pull out the power plug
Move cutting head away
Empty cut material container
Replace cutting head
Note: The fill level sensor is on the underside of the cutting head. Clean the sensor
if the "Bin Full" display remains on even after the container for shredded material has
been emptied.
TROUBLESHOOTING
SHREDDER WILL NOT OPERATE
1. Make sure shredder is plugged into power source and the main power
switch is switched on.
2. Make sure the cutting head is placed correctly on the shredded material
container.
PAPER JAM
1.
Press and hold REV button to clear the jam.
2.
Press power button to continue shredding.
CAUTION: Sharp cutter blades. Do not reach underneath the shredder head to
remove jammed paper. Serious injury can result.
SHREDDER STOPS WHILE SHREDDING
1.
Switch off the main power switch and unplug the shredder from the power
source.
2.
The light barrier in the paper feed is soiled with paper dust. Clean the
sensor with cloth.
3.
Plug shredder back in to power source and turn on.
4.
For further troubleshooting, please contact product support 800-613-2110.
Advertisement
