Introduction; Product Overview; Unpacking Instructions And Typical Package Contents; Plate - Scanlab hurrySCAN 10 Installation & Operation Manual

1

Introduction

This operating manual describes the hurrySCAN
scan head with ID number 112466 together with an
objective (ID number 100832).
The manual is a part of the product. Please read these
instructions carefully before you proceed with
installing and operating the scan head. In particular
observe all safety guidelines in this manual. If there
are any questions regarding the contents of this
manual, please contact SCANLAB (see
Keep the manual available for servicing, repairs and
product disposal. This manual should accompany the
product if ownership changes hands.
SCANLAB reserves the right to update this operating
manual at any time and without notification.

1.1 Product Overview

®
The hurrySCAN 10 scan head with ID number
112466 is designed for positioning laser beams with
a wavelength of 1064 nm and is equipped with a
10 mm aperture.
The scan head is designed for digital signal transfer
via the integrated digital interface.
The objective with ID number 100832 has a focal
length of f = 254 mm and is designed for a wave-
length of 1064 nm.
The technical specifications of the product are
summarized on page 34.
®
hurrySCAN 10, digital, 1064 nm, f = 254 mm
Rev. 2.6 e
1 Introduction
®
1.2 Unpacking Instructions and
10
Typical Package Contents
Carefully remove the scan head from the
package.
Protect the scan head from dust and other
contaminants.
Keep the packaging, so that in case of repair the
page 32).
scan head can be properly repackaged and
returned to SCANLAB.
Also remove all other articles from the package.
Check that all parts have been delivered. Please
refer to the corresponding packaging list.
A scan head package typically includes a product
test protocol with test data. For mounting an
objective an objective mounting set may be
included in the package or already mounted to
the scan head. For controlling the scan head, an
®
RTC
package.
1.3 I.D. Plate
The scan head's I.D. plate (see
head's serial number is found on the housing.
I.D. plate with serial number (SN)
control board may be included in the
figure
Siemensstr. 2a · 82178 Puchheim · Germany
Typ
hurrySCAN
SN
1064 nm
1) with the scan
®
10
1
5