Safety During Installation And Operation; Operational Guidelines And Standards - Scanlab hurrySCAN 10 Installation & Operation Manual

3

Safety During Installation and Operation

To reduce the risk of injury, please observe the
following guidelines.
The safety and warning notices in this manual are
indicated by a symbol set against a gray
background:
Instructions that may affect a per-
!
son's health are marked with a
warning triangle next to the word
"Danger".
Instructions that recommend appro-
priate use of this device or warn of
damage that may occur to it are iden-
tified by a circle with an "X" in it, next
to the word "Caution".
3.1 Operational Guidelines and
Standards
When operating the scan head, the following guide-
lines and standards should be followed:
• EC Guideline 73/23/EEC
Low Voltage Directive
(including amendment 93/68/EEC)
• EC Guideline 89/336/EEC
Electromagnetic Compatibility
(including amendments 91/263/EEC, 92/31/EEC,
93/68/EEC and 2004/108/EU)
• EC Guideline 98/37/EU
Machinery Directive
• EN 60204-1 (November 1998)
Safety of Machinery – Electrical Equipments of
Machines, Part1: General Requirements
(also see similar general machinery safety stan-
dards such as VDE 0113-1, IEC60204-1 or ANSI
B11.19 Machine Tools – Safeguarding When
Referenced by Other B11 Machine Tool Safety
Standards-Performance Criteria for the Design,
Construction, Care and Operation)
• EN 60825-1 (October 2003)
Safety of Laser Products, Part 1: Equipment Clas-
sification, Requirements and User's Guide
(also see similar general laser safety standards
such as VDE 0837-1, IEC 60825-1, Safety of Laser
®
hurrySCAN 10, digital, 1064 nm, f = 254 mm
Rev. 2.6 e
3 Safety During Installation and Operation
Products - Part 1: Equipment Classification,
Requirements, and User's Guide, 21 CFR 1040,
Laser Product Performance Standard or ANSI
Z136.1 Standard for the Safe Use of Lasers)
• EN 12626
Safety of Machinery - Laser Processing Machines -
Safety Requirements
(also see similar laser materials processing system
safety standards such as ISO 11553, Safety of
Machinery - Laser Processing Machines - Safety
Requirements, IEC 60825-4, Safety of Laser Prod-
ucts - Part 4: Safety of Laser Products or ANSI
B11.21-1997, Machine Tools Using Lasers for
Processing Materials - Safety Requirements for
Design, Construction, Care, and Use)
Additional application-dependent guidelines and
standards may apply.
Complying with the Relevant Standards for
the CE Label
®
The hurrySCAN 10 is delivered as an OEM compo-
nent conceived of for integration into a laser scan
system.
The system manufacturer bears the responsibility for
complying with the standards and guidelines
required for equipment usage and for the CE label.
Scan Head Conformity to EC Guidelines for
Electromagnetic Compatibility (EMC)
The scan head is in conformance with EC guidelines
89/336/EEC (electromagnetic compatibility).
Electromagnetic fields that exceed these standards
can affect the operation and operating safety of the
scan head and therefore require special shielding.
For more information, see the section "Electromag-
netic Compatibility" on page 35.
12